Stitched with their hands bright case in the form of a pencil will be a nice gift and will raise the mood of its owner.
We need: cotton fabric in two colors, small pieces of linen, fleece, fleece as a lining (can be replaced by a layer of any soft tissue with synthetic padding), thread, disk cutting out a knife or scissors, ruler.
Cut details of the future of the case modeled on the in the photo. They have already laid
seam allowances equal to 7mm. The width of long parts can range from the size of your glasses. For example, if you plan to sew foulard glasses for reading will be sufficient width 3.5 cm, if the same points of a larger size, cut out parts 4 cm wide. All Fusible interfacing strip sizing.
We begin to sew together the long parts of 3 pieces, alternating through one color. Allowances iron out the seams.
Sew the resulting blocks with short details. Allowances iron out the seams.
On the wrong side of the mark up the angle of stitching details, leaving the seam allowances to 7 mm in width. , Cut off the excess.
According to obtain a preform cut out pencil liner. It is better, if it is 1.5 cm. Shorter than the main part, then the joint between them will be located inside the case. Sew together the short straight sides and a pencil liner.
Fold the resulting workpiece to each other face, shearing, aligning seams details. Retreating 7 mm from the edge, sew the details, do not forget to leave the details of backing a short distance. To turn out the product.
The remaining section of neatly sewn up by hand.
Put lining inside the case, fasten it with a pair of hidden stitches to the main part.
0 comments:
Post a Comment