Detail instructions beside the photos make you follow the steps easily. Finished width: 7.5 inches x 4.75 inches. Flip-top bag, envelope bag making tutorial
This small bag with a compartment in the middle, the complete size → length 16 cm; height 9.5 cm, you can put mobile phones, change, keys and other small belongings.
DOWNLOAD PDF PATTERN
2. Then trim the paper pattern neatly along the dotted line on the inside. We use it to cut one piece of auxiliary cotton (or auxiliary cotton + double-sided adhesive) with glue. For thickening, the upper part of the large paper pattern can be used to cut a piece of auxiliary cotton, the height is about 5~6 cm→
3. The glued auxiliary cotton is ironed and glued to the back of the table cloth, and the covered auxiliary cotton is ironed on the back of the lining cloth. The remaining two pieces of table cloth are used as interlayers, and there is no need to add lining→
4. On the lined pieces of cloth, magnetic buckles, decorative buckles, cloth labels and other embellishments are installed separately.Note that the magnetic buckle of the bag cover is mounted on the lining→
5. I have taken two pieces of unlined table cloth + 2 pieces of lining cloth, and we want to use them to make a sandwich.First, align the upper edge of the suture one-to-one, face inward, and cut some teeth on the seam after the suture is completed.Then turn the surface so that the back is attached to the back, and iron the upper edge→
6. Draw a suture on the back of one of the compartments (marked on the paper type), then align the two compartments inward and suture along the drawn suture.In this way, the sandwich in the middle is made, and the small bag in the middle is just right for bank cards and transportation cards~~
7. Take the watch cloth with the magnetic buckle and the remaining piece of lining cloth, sew the upper edge and turn it over and iron it.They will be used as the predecessor of the bag→
8. Then we have to sew the predecessor of the bag with the sandwich.It depends on the details~ As shown in the figure below, the upper half of the compartment is folded inward (the purpose is to make way for the other half of the stitching), and then the bag and the table lining are separated and flattened, ready to be ready.Spread the table cloth surface of the predecessor on the top of the compartment, align with the lower half of the edge of the compartment and sew→
9. The picture below on the left shows the seam and what it looks like afterwards.Then turn the lining cloth of the predecessor over and cover it on the right as shown in the figure below, align it with the bottom sandwich and the edge of the predecessor table cloth, and sew it for 3 weeks, leaving a return port at the bottom.In this way, the sandwich is sandwiched in the middle by the predecessor's table cloth→
10. Turn out the front and middle layers of the bag from the return mouth, which is what it looks like in the picture below. The front bag has been made→
11. Now sew the other half of the sandwich with the flip of the back of the bag.If you need to install a strap, don't forget to sew a buckle before stitching it.
When we stitched the predecessor in front, we first sewed a complete table cloth and then sewed the lining cloth. Here we stole the lazy ~~Align the bottom edge of the back table cloth and the sandwich, and sew a length of about 10 cm in the middle part.
Then spread the back lining cloth on it, align the surrounding edges and sew a circle, leaving a 7 or 8 cm long return mouth in the center of the bottom→
12. Turn the bag out of the return port and sew the return port on the lining.There is also a return port in the front pocket, and it must also be stitched up→
14. Straighten and iron the edges and corners of the bag, and press a circle of thread on the edge of the clamshell or hand-stitched or machine-stitched.Finally, put a strap on the bag, and the bag is finished→
0 comments:
Post a Comment