Bunny Pencil Pouch Tutorial

DIY Bunny Pencil Case | DIY Pouch | DIY Back to School. Free Pattern and Tutorial

Finished size → 20 cm long

Pattern

1. Cut the fabric according to the paper pattern, the fabric should be cut according to the cutting line, and the auxiliary cotton should be cut to a rough outline, and then trimmed. 2.

2. first to sew the two ears of the bunny, as shown in the figure below, the two layers of fabric face to face aligned on the auxiliary cotton, the opening of the seam folded to the opposite side of the fabric, the bottom layer of the auxiliary cotton wrapped around the edges, which is more convenient than turning to the front and then folded edges → 

After sewing, cut some notches on the curved edges, trim the auxiliary cotton neatly close to the seam line so that the lines of the seams will look smoother when you turn it to the front, and after that turn the two ears to the front and set them aside;

3. Lay the fabric face up on the auxiliary cotton. Sew around the perimeter, the seam allowance should be narrower, 0.3 to 0.5 centimeters, because this line only serves to hold the fabric in place, if it is too wide, the seam will be visible on the front of the finished work, which is very unsightly. After completing the sparse sewing, the auxiliary cotton will be trimmed to the same size as the fabric →

4. Next, attach the zipper to the back of the bunny → when the zipper is closed, the head of the zipper should face the tail of the bunny, and the zipper should be sewn with the front side down and the edge of the fabric aligned.

5. After both sides of the zipper are sewn, in the appropriate place to sew on the bunny ears, you can use hand sewing, only the opening of the ears sewn to the fabric can be → 

6. Sew the left and right sides of the bunny together → When sewing, take the zipper teeth as the fold, and take care to pull the zipper head to the center; after sewing, trim the seam allowance a little narrower, and cut some slits at the turning position, so that it is easy to turn to the front. Reinforce the teeth of the zipper at the beginning and end of the seam with a hand sewing needle around the seam a few times, and then cut off the excess zipper at both ends.

7. Turn to the front, the outer layer of the bunny pen bag has been done; then do the lining, because the lining is a piece of type, as long as the folded sewing ends can be, in order to facilitate the back of the sewing, the mouth of the bag should not be sewn to the edge of the remaining seam width!

8. Stuff the lining into the pen case, align the seams at both ends, and sew the edges of the lining to the inside of the zipper with a hand sewing needle.

9. Finally, cut a piece of fabric with a diameter of about 6 centimeters, sew a circle around the edge with a hand sewing needle like YOYO, stuff a little bit of cotton and tighten the threads to make a ball, and tie the ball to the zipper head as the bunny's tail.